Remember, a port has multiple pins. Thus in order to change setting for one port, you have to change setting for all port pins of that port. To change setting for one single pin of the port, you have to change a particular bit in associated register. Got that? If not read this para again. Registers Atmel AVR is 8 bit microcontroller.
|Published (Last):||14 November 2008|
|PDF File Size:||14.9 Mb|
|ePub File Size:||19.40 Mb|
|Price:||Free* [*Free Regsitration Required]|
These cookies do not store any personal information. Non-necessary Non-necessary Any cookies that may not be particularly necessary for the website to function and is used specifically to collect user personal data via analytics, ads, other embedded contents are termed as non-necessary cookies.
It is mandatory to procure user consent prior to running these cookies on your website.
Have one to sell? Would you like to tell us about a lower price? Share Facebook Twitter Pinterest. The Manufacturers reserve the right to change this Information at any time without notice.
ATMEGA162-16PU Atmel, ATMEGA162-16PU Datasheet
In addition the Power Debugger has two independent current sensing channels for measuring and optimizing the power consumption of. Thank you for your feedback. Runtime calibration and compensation of RC oscillators. The AVR device connects to the STK using an innovative routing and socketcard sandwich system, which routes the signals from the device to the appropriate Allowing you to reduce waste and avvr production efficiency. In addition the Power Debugger has two independent current sensing channels for measuring and optimizing the power consumption of Atmel Studio — Software Development Environment. Only show products with samples. Application Notes Download All.
Atmega162-16au Atmel ATMEGA 162 AVR Controller Tqfp44
Vom laufenden Programm aus kann man das ROM normalerweise nur lesen, nicht beschreiben. Es kann beliebig oft gelesen und mindestens Bei den AVRs kann man es z. Nun sollen aber auch vom laufenden Programm aus Daten ausgelesen werden. Um die Daten wieder auszulesen, muss man die Adresse, auf die zugegriffen werden soll, in den Z-Pointer laden. Wenn die richtige Adresse erstmal im Z-Pointer steht, geht das eigentliche Laden der Daten ganz einfach mit dem Befehl lpm.